本文へスキップします。

【全・英】スマホお問い合わせボタン
【全:英】代理店
【全:英】ログインボタン
【全:英】サイトマップ
【全・英】ヘッダ検索
 
Search
【全:英】検索
【全・英】お問い合わせボタン
H1

Plating thickness and oversized tap

【英】困ったときの知恵袋詳細
Cutting TapsRoll (Forming) TapsRound DiesThread Mills Metric ThreadsUnified ThreadsWhitworth Threads Helical Coil Wire Screw Thread InsertsPipe ThreadsSpecial Threads Basic Knowledge
I have a question about applying a plating after cutting an internal thread with metric tap. For example, when applying a 10 μm thick plating on a flat surface, the plating thickness needs to be 10 μm. When applying a plating on an internal thread, how much larger does the tap need to be over a standard tap size to create a 10 μm plating thickness?
Basically, when a plating is applied to an internal thread, the pitch diameter of the internal thread will be reduced by four times the plating thickness. In this example, it would be 10 μm × 4 = 40 μm, so it is recommended to use an oversized tap with a standard tap limit accuracy of + 40 μm.

Document