Torn Taper Pipe Threads

【英】困ったときの知恵袋詳細

Cutting Taps Pipe Threads Trouble Shooting

I have a torn thread problem when tapping a taper thread with a SP-PT tap while using a fully synchronous feed on a machining center. The tap is held in a solid rigid type holder, but the problem occurs when I tap at the recommended speed.

You can solve your problem by replacing the solid type holder with a tension/compression type tap holder.

Document

【全:英】FIXメニュー

Bag Full of Wisdom
when you are in trouble
Product Catalog

ページトップへ